Fritz! WLAN 310 Installation And Operation

Fritz! WLAN 310 Installation And Operation

Advertisement

FRITZ!WLAN Repeater 310 Installation and Operation Instructions
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FRITZ!WLAN 310 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Fritz! FRITZ!WLAN 310

  • Page 1 FRITZ!WLAN Repeater 310 Installation and Operation Instructions...
  • Page 2 FRITZ!WLAN Repeater 310 Installation and Operation Instructions Button and LEDs The Fritz!WLAN Repeater has a button and various LEDs on the front panel. Button The Following functions are operated using the button: Function Press for at Least Switch wireless LAN on and off...
  • Page 3 The SSID of a Fritz!Box is visible upon delivery. • If a MAC address filter is active in your WLAN base station, the MAC address of the Fritz!WLAN Repeater must be entered there as an exception. You can also disable the MAC address filter...
  • Page 4 Connecting Fritz!WLAN Repeater via WPS with Fritz!Box This section describes how to connect the Fritz!WLAN Repeater with any other WLAN base station that supports WPS as described below. In this case, please also take note of the instruction in the documentation of your WLAN base station.
  • Page 5 FRITZ!WLAN Repeater 310 Installation and Operation Instructions Now press the “WLAN” button on the Fritz!Box within the next two minutes. Hold the “WLAN” button down until the “WLAN” LED of the Fritz!Box begins flashing. This takes about 6 seconds. The connection between the Fritz!WLAN Repeater and the Fritz!Box has been established when the LEDs that display the strength of the wireless radio signal stop flashing and remain lit.

Table of Contents