LG AMNH096VEA0 Service Manual page 107

CST Type Remote Controller
Operation display
1
Displays the operation conditions.
On/Off Button
2
Operation starts when this button is pressed, and
stops when the button is pressed again.
Set Temperature Button
3
Used to set the temperature when the desired temper-
ature is obtained.
FAN Operation Button
4
Used to circulate room air without cooling or heating.
Fan Speed
5
Used to set the desired fan speed or select Jet cool
mode.
Operation Mode Selection Button
6
Used to select the operation mode.
• Auto Operation Mode
• Cooling Operation Mode
• Soft Dry Operation Mode
• Heating Operation Mode(except cooling model)
Auto Swing Button
7
Used to swing up and down/right and left(option)
Room Temperature Checking Button/Filter sign
8
Release(Option)
Used to check the room temperature.
❈ Display temperature can be different from actual room temperature if the remote controller is installed at the
place where sun-rays are falling directly or the place nearby heat source.
Note : 06 Model - AMNH09GTCC0, AMNH12GTCC0
AUTO SWING OPERATION SET TEMP
2ndF
Timer Operation unit No Func Program set
On Off
01 03 05 07 09
Set no. Time
3
17
10
Timer Cancel 2ndF
11
12
Program Week Holiday
13
Plasma
14
Set/Clr
15
Hour Min
16
18
FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO SLO Filter Out door
Time ZONE 1 2 3 4
11 13 15 17 19 21 23
RESET
Plasma Air Clean Button (Option)/Heater(Option)
9
Timer Cancel Button
10
Used to cancel the timer.
Timer Set Button
11
Used to set the timer when the desired time is
obtained.
Week Button
12
Used to set a day of the week.
Program Button
13
Used to set the weekly timer.
14 Holiday Button
Used to set a holiday of the week.
15 Time Set Button
Used to set the time of the day and change the time in
the weekly timer Function.
Set and Clean/Ventilation(Option)
16
Used to set and clear the weekly timer.
17 Swirl Button
Used to select swirl mode.
Jet Cool Button
Auto Swing Button(1 Way 06 Model)
18
Reset Button
Used to set the current time and clear the setting time.
1
2
5
6
4
7
8
9
Service Manual 107
Operation