Remote Controller Installation - LG AMNH096VEA0 Service Manual

Multi type air conditioner
Hide thumbs Also See for AMNH096VEA0:
Table of Contents

Advertisement

Remote Controller Installation

• Although the room temperature sensor is in the indoor unit, the remote controller should be installed
in such places away from direct sunlight and high humidity.
Installation of the remote controller
• Select places that are not splashed with water.
• Select control position after receiving customer approval.
• The room temperature sensor is built in the indoor unit.
• This remote controller equipped with liquid crystal display. If this position is higher or lower, display is difficult
to see.(The standard height is 1.2 ~ 1.5m high)
Routing of the remote controller cord
• Keep the remote controller cord away from the refrigerant piping and the drain piping.
• To protect the remote controller cord from electrical noise, place the cord at least 5cm away from other power
cables (audio equipment, television set, etc.)
• If the remote controller cord is secured to the wall, provide a trap at the top of the cord to prevent water
droplets from running.
WIRED REMOTE CONTROL INSTALLATION
DISASSEMBLING
Front case
Lever carefully
the box open
using a screw
driver, etc.
• Fix the under plate on the wall
Face of wall
Under plate
Screw (accessory)
ELECTRICAL WIRING
Remote control
box body
(Main board)
CN REMO
Wire and make sure that teminal
numbers are matched on unit side and
The maximum length of the cord is 100m.
If the length of the cord exceeds 50m,
use a wire size greater than 0.5mm
• Separate the under plate from Remote control box.
• Fix the cord clamps on the wall by ø 3 tapping
screws (accessory).
• Fix the remote control cord.
remote controller side.
2
.
Cord clamp
(accessory)
Remote controller
Service Manual 69
Installation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents