Installation And Operation; Unpacking; Selecting Installation Position; Installation Of Accessories Kit - Orvaldi MSII RT 6-10KVA User Manual

3. Installation and Operation

The packing condition and the external outlook of the unit should be
inspected carefully before installation. Retain the packing material for future use.

3.1. Unpacking

3.1.1. Take the UPS out of the PE foam.
3.1.2. Unwrap the UPS.
3.1.3. Standard Package includes:
1 set of Quick Start Manual
1 set of User's Manual
1 set of UPS communication software with RS232 cable
1 set of Metal Accessories Kit for Tower model or RT model as below:
3.1.4. Package for the UPS with Isolation transformer & dual input:
Ditto, but with additional 3pcs wire No 7.
3.1.5. Package for the UPS without isolation transformer but dual input:
Ditto, but with additional 1pcs wire No. 7.
(p.s. Wire No. 7 is to be used at the input/output terminal block of the UPS.
Please refer to Chapter 3.4 for installation.
Tower model
A1
RT model
x4
B1 B2
x2
x2
S1 S2
x2 x4
RT10K only
A1 X1
A2
A2 A3
x4 x1
B3 B4
for 2U
for 3U for 4U
x2 x2
S3 S4
x8 x6
X1
A3 X2
14

3.2. Selecting Installation Position

It is necessary to select a proper environment
to install the unit, in order to minimize the
possibility of damage to the UPS and extend the
life of the UPS. Please follow the advice below:
1. Keep at least 30cm (12 inches) clearance
from the rear panel of the UPS to the wall.
2. Do not block the air-flow to the ventilation
openings of the unit.
3. Please check the installation site to avoid
overheat and excessive moisture.
4. Do not place the UPS in an environment near
dust, corruptive or salty material or flammable
objects.
5. Do not expose the UPS to outdoors.

3.3. Installation of Accessories Kit

S3
S3
B1 B2 S4 B1 B3 S4
0℃
Relative humidly
(non condensation) 30% ~ 90%
S3
15
40℃