Setting The Lens And Switches - JVC TK-C215VP12 Instructions Manual

Introduction

Setting the Lens and Switches

Set the video setting switches on the camera unit before mounting it.
To set the switches, use a fine-tipped screwdriver.
A
B
C
D
E
A
[RESET/SPOT] RESET/SPOT button
When this button is pressed, the value of the
white balance or phase adjusted manually is
reset to the default value.
● When the 2 [SELECT] switch is set to
WHT.BAL., the white balance is reset to the
default value.
When the switch is set to PHASE, the phase
is reset to the default value.
● When setting to SPOT:
When this button is pressed, white spots are
corrected.
For instructions on correcting white spots,
see White-spot correction (A Pg. 28).
B
[R/B,+/-] R/B,+/- adjustment button
This button is pressed when manually
adjusting the white balance or when adjusting
the vertical phase of the line lock.
The function of this button is selected using
the 2 [SELECT] switch.
● When manually adjusting the white balance:
Press the R button to increase the red tint
and decrease the blue tint.
Press the B button to increase the blue tint
and decrease the red tint.
● When adjusting the phase:
Press the + or - button to adjust the phase.
12
RESET/ [ SPOT ]
LL PHASE
O
1
N
2 2
3
4 4
5
WHT.
6
7 BAL.
8
L H
IRIS
LEVEL
FOCUS ADJUST
Function Selection Switch Settings Chart
(Characters in bold indicate factory settings)
OFF
AGC OFF
1
2 SELECT PHASE
3 SYNC LL
ATW
4 WHT.BAL.
OFF
5 BLC
OFF
6 DAY/NIGHT
7 RESERVED SET TO OFF
RESET
8 RESET/SPOT
C
Function selection switches
1. [AGC] Auto-gain control switch.
Setting this switch to ON automatically
increases the sensitivity even when the
brightness of the subject is insufficient.
(Default setting: ON)
2. [SELECT] WHT.BAL./PHASE setting
switch.
WHT.BAL.:
The B [R/B,+/-] buttons are used as [R/B]
adjustment buttons.
PHASE:
The B [R/B,+/-] buttons are used as [+/-]
adjustment buttons.
(Default setting: WHT.BAL.)
F
G
ON
ON
WHT.BAL.
INT
MANU
ON
ON
SPOT