Removing The Dsp Board And Motor Board; Removing The Cpu Board; Removing The Ccd Board; Removing The Lens Assembly - JVC TK-AM200U Service Manual

1.4.2 Removing the DSP board and MOTOR board

(1) Remove the POW board as described in 1.4.1.
(2) Pull out the main body in the direction of the arrow g and
remove the chassis cover
Î
Fig. 1-4-2 (a)
(3) Remove the two screws
(4) Pull out the DSP board in the direction of the arrow g, and
then remove the DSP board.
DSP board
5
Fig. 1-4-2 (b)
(5) Also remove the MOTOR board on the opposite side to the
DSP board in the same way as the DSP board.

1.4.3 Removing the CPU board

(1) Remove the DSP board and the MOTOR board as described
in 1.4.2.
(2) Remove the three screws
CPU board
Fig. 1-4-3
1-2
Î
.
5
and disconnect CN2.
CN2
6
, and then remove the CPU board.
6

1.4.4 Removing the CCD board

(1) Follow (1) to (4) in 1.5.

1.5 REMOVING THE LENS ASSEMBLY

Note:
When removing the lens ass'y, be careful that metallic
objects such as the tip of a screwdriver or a screw etc.
do not come into contact with the magnet. If a metallic
object touches the magnet, the sensor may be destroyed.
Fig. 1-5 (a)
(1) Remove the two screws
7
Fig. 1-5 (b)
(2) Remove the two screws
´
the lens .
´
Fig. 1-5 (c)
Magnet
7
.
8
and disconnect CN2 and remove
8
CN2