Sym GTS 250 Service Manual page 207

17. Electrical System
Replacement headlight bulbs
Remove wind screen garnish, wind screen, meter
visor, front cover.
(Refer chapter 13)
Disconnect the rubber sleeve and the terminal
coupler from the headlight.
Loosen 1 screw from the headlight bulb setting
stay.
Remove setting stay and take out the headlight
bulb.
Replace with new bulb if necessary.
Specification:
Lo-beam bulb 12V 55W (H7)
Hi-beam bulb 12V 55W (H7)
Caution
Never touch the bulb with finger, which will
create a heat point.
Clean the fingerprint left on the bulb with
alcohol.
Installation
Install the bulb of the headlight in reverse order of
removal.
Upon completion of replacement, turn on the main
switch to ensure the headlight works well.
Adjust the beam and distance of the headlight if
necessary.
17-16
To this chapter contents
1 screw
Setting stay
1 screw
Setting stay
Hi-beam adjustment screw
Coupler
Lo-beam
Coupler
Hi-beam
Lo-beam adjustment screw