Fuel Unit - Sym GTS 250 Service Manual

Scooter
Hide thumbs Also See for GTS 250:
Table of Contents

Advertisement

Fuel Unit

Open the seat.
Remove the luggage box.
Remove the rear carrier.
Remove right & left side cover.
Remove the body cover
Remove the floor panel.
Disconnect the coupler of the fuel unit.
Loosen 4 bolts from fuel unit and remove it.
Caution
Great care shall be taken not to damage or
bend the float arm of the gauge.
When the float arm shifts to the F position or the E
position, the resistance measured shall be as
follows:
Position
E (Empty)
F (Full)
Connect the wiring to the fuel unit and the
ohmmeter as shown.
Connect the fuel unit coupler to the wire harness.
Turn on the main switch.
Move the float arm to verify the proper position the
fuel gauge needle indicates.
Arm Position
Up (Full)
Down (Empty)
Caution
While conducting the test, turn on the direction
indication lamp to make sure that the battery is
in serviceable condition.
To this chapter contents
Resistance
97.5~107.5 Ω
4~10 Ω
Needle Position
F (Full)
E (Empty)
17. Electrical System
Fuel unit
Fuel unit coupler
Full
Empty
17-21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lm25w series

Table of Contents