Removing The Pcb - Pioneer DV-505 Instruction And Installation Manual

Pioneer DV-505
Step 3 -

3.2 Removing the PCB

Step 1 -
Step 2 -
Lift the cover and remove
Lift the cover at the rear
first and then hinge up to
about 45 degrees, then
move cover away from
the base.
Locate the Video/Logic PCB
Disk Tray
Remove the shielding from the board
Remove the two screws that
secure the left-hand side of
the shielding to the PCB.
Be careful to note how
the protruding post keeps
the ribbon cable from
fowling the disk tray.
Unhook the
shield from the
right hand side
notch in the PCB.
Rear Panel
Front Panel
PCB
Page 11
Code Switchable Modification
The Video/
Logic PCB
Shielding
continued over...