6. ECO-SOL MAX ink: Installing the Ink Cartridges
ECO-SOL MAX ink: Filling with Ink for the First Time
On ECO-SOL MAX ink models, special procedures are required when installing ink cartridges for the first time. These are
required only once, when installing ink cartridges for the first time after shipment from the factory.
You first clean the print heads using cleaning fluid, then fill with the inks of the various colors. This operation requires two
SOL INK cleaning cartridges.
Never under any circumstances use anything other than the specified type of ink or cleaning fluid.
ECO-SOL MAX ink: Installing the Ink Cartridges
For AQUEOUS PIGMENT ink models P. 32
Be sure to follow the on-screen instructions
for insertion and removal.
Keep the labeled side face up.
Insert and remove slowly, one at a time.
Insert firmly, as far as it will go.
Insert firmly until you hear a beep.
During cleaning, you insert and remove cartridges several times. The on-screen messages indicate which to insert and remove,
and when to insert and remove them.
Insert each color ink cartridge into the slot labeled with the matching color. The cleaning cartridges are not differentiated
by color.
CAUTION
Never insert your hand or fingers into the opening of the front cover.
The print heads move at high speed inside the cover. Contact may cause injury.
Slot number
1
2
3
4
35