Honeywell KAP 140 Pilot's Manual page 47

N
3
4
D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
PUSH
G
KAP 140
AP HDG NAV
3. At the desired point, HDG mode is used to initi-
ate the procedure turn. Select HDG and set the
heading bug to 283°. During the procedure turn
outbound, the CDI course index goes off scale
to the right. The aircraft is flying away from the
localizer centerline at a 45° angle on a selected
heading of 283°.
* Check the heading displayed on the DG against
the magnetic compass and reset if necessary.
Rev. 1
Apr/02
270°
N
TO
A
V
GS
FR
OBS
ı
APR REV
KAP 140 AUTOPILOT SYSTEM
Single Axis Operation
2
D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
PUSH
G
KAP 140
AP HDG NAV APR
4. Now you have reset the heading bug to 103°
and made a 180° turn to this heading. This
103° heading will intercept the front course of
058°. You must now select the approach mode
by depressing the APR button on the KAP 140.
While the HDG annunciation is flashing move
the heading bug to the front course 058°. Since
the 45° intercept is 103°, the aircraft will not
turn until the front course is captured.
1
N
TO
A
V
GS
FR
OBS
ı
REV
39