Panasonic FZ-M1 Operating Instructions Manual page 15

This device meets the government's
requirements for exposure to radio
waves.
This device is designed and manu-
factured not to exceed the emission
limits for exposure to radio frequen-
cy (RF) energy set by the Federal
Communications Commission of the
U.S. Government.
The exposure standard for wireless
device employs a unit of measure-
ment known as the Specifi c Absorp-
tion Rate, or SAR. The SAR limit set
by the FCC is 1.6 W/kg.
* Tests for SAR are conducted us-
ing standard operating positions
accepted by the FCC with the
device transmitting at its highest
certifi ed power level in all tested
frequency bands.
Although the SAR is determined
at the highest certifi ed power
level, the actual SAR level of the
device while operating can be well
below the maximum value. This is
because the device is designed to
operate at multiple power levels
so as to use only the poser re-
quired to reach the network. In
general, the closer you are to a
wireless base station antenna, the
lower the power output.
<Only for model with wireless LAN>
This product is restricted to indoor
use due to its operation in the 5.15
GHz
to 5.25 frequency range. FCC
requires this product to be used in-
doors for the frequency range 5.15 to
GHz
5.25 to reduce the potential for
harmful interference to co-channel
Mobile Satellite systems. High power
radars are allocated as primary users
of the 5.25 to 5.35
GHz
5.85 bands. These radar stations
can cause interference with and/or
damage this product.
GHz
and 5.65 to
25-M-W-1
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Responsible Party:
Panasonic Corporation of North
America
Two Riverfront Plaza
Newark, NJ 07102
Support Contact:
http://www.panasonic.com/
contactinfo
FCC RF Exposure Warning:
This equipment is provided with
external antenna connector(s) for
connection to optional Car Mounter
or Port Replicator for mobile exter-
nal mounted antenna(s). External
antenna(s) must be professionally
installed and cannot exceed recom-
mended maximum antenna gain
as described in individual provided
supplement instructions for wireless
transmitters. The Car Mounter is
provided with Radiall/Larsen WLAN
whip antenna, type NMO5E2400B-
KTNC with 5dBi antenna gain.
The maximum allowable antenna
gain for the external WWAN base
whip antenna for the cellular band
is 4 dBi, PCS band is 3 dBi, LTE
Band 4 is 3 dBi, LTE Band 17 is
9 dBi and 10 dBi for LTE Band 13.
Also, user must maintain minimum
20 cm spacing between external
antenna(s) and all person's body
(excluding extremities of hands,
wrist and feet) during wireless
modes of operation.
6-M-1
32-M-1
15