Summary of Contents for Kirkland Signature 720-0193
Page 1
ASSEMBLY & OPERATING INSTRUCTIONS 4 00 6 00 8 00 FOR OUTDOOR USE ONLY Model: 720-0193 PLEASE CONTACT 1-866–984–7455 FOR ASSISTANCE ABOUT ASSEMBLY OR GRILL OPERATION DO NOT RETURN TO THE PLACE OF PURCHASE...
Page 2
DANGER If you smell gas: Shut off gas to the appliance. Extinguish any open flames. Open lid. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. WARNING Do not try to light this appliance without first reading the “LIGHTING INSTRUCTIONS”...
MESSAGE TO OUR CONSUMERS Thank you for selecting our stainless steel gas grill. Because this appliance contains features which may not found on other grill, we recommend that you read this entire booklet before your first use. Keep it in handy place as it has answers to questions that may occur during future use.
PRECAUTIONS SAFETY PRACTICES TO AVOID PERSONAL WARNING INJURY Do not try to light this appliance without first reading the “LIGHTING When properly cared for, your stainless INSTRUCTIONS” section in this manual. steel grill will give safe, reliable service for many years. However, extreme care must be used since the grill produces intense TESTED IN ACCORDANCE WITH ANSI heat and that can increase accident...
Page 5
PRECAUTIONS DO NOT STORE ITEMS OF INTEREST Moist or damp potholders on hot surfaces TO CHILDREN AROUND OR BELOW may cause burns from steam. Do not use a THE GRILL OR IN THE CART. NEVER towel or bulky cloth in place or potholders. ALLOW CHILDREN TO CRAWL INSIDE Do not let potholders touch hot portions of OF THE CART.
PRECAUTIONS Do not use the grill for cooking outside in a well ventilated area, out of the excessively fatty meats or products which reach of children. promote flare-ups. Do not operate the grill DO NOT USE BRIQUETTES OF ANY under unprotected combustible KIND IN THE GRILL.
ASSEMBLE INSTRUCTIONS ASSEMBLY INSTRUCTIONS PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP. TOOLS REQUIRED: (1) PHILIPS HEAD SCREWDRIVER – NOT PROVIDED STEP 1:The screws used to attach the side shelf are already screwed into the left panel (see the figure below).
Page 8
ASSEMBLY INSTRUCTIONS STEP 2:The screws used to attach the push bar are screwed into the back of the push bar. align the holes on the front side of the side shelf, and then tighten up the screws to assemble the push bar.
Page 9
ASSEMBLY INSTRUCTIONS STEP 3:The screws used to attach the push bar are screwed into the right panel (see the figure below). align with the holes in the push bar, and then screw into the holes on the right panel of the grill.
Page 10
ASSEMBLY INSTRUCTIONS STEP4: Find the 4 screws used to attach the left and right push bar brackets. Align the holes for each bracket with the holes on the right panel beneath the push bar. Insert the screws and loosely attach the brackets. Locate the 2 screws which will attach each bracket to the push bar itself, as shown in the diagram below.
Page 11
ASSEMBLY INSTRUCTIONS STEP 5: Battery is inserted for the Rotisserie burner . To install the battery, turn the ignition button cap counterclockwise and remove it. Replace the ignition button cap after the battery are installed.
Page 12
ASSEMBLY INSTRUCTIONS STEP 6: Attach propane gas tank to regulator inlet fitting by turning the regulator clockwise as shown in figure below. LP gas cylinder must be fitted with a listed overfill prevention device (OPD). Secure liquid propone gas cylinder to the slide out tray using the gas cylinder retention screw.
Page 13
ASSEMBLY INSTRUCTIONS STEP 7: The screws for rotisserie drive motor bracket are screwed into the right side of the grill housing. Remove the screws and install the rotisserie motor bracket as shown in the figure below. Assemble the rotisserie skewer as shown in the figure below. 4 sets each side...
GAS HOOK-UP NEVER CONNECT AN UNREGULATED QCC1 in the standard for compressed gas GAS SUPPLY LINE TO THE APPLIANCE. cylinder valve outlet and inlet connection USE THE REGULATOR/HOSE ANSI/CGA-V-1. ASSEMBLY SUPPLIED. Manifold pressure: 10”(25.4cm) water This is a liquid propane configured grill. column (W.C.).
GAS HOOK-UP 5. When connecting regulator assembly to To disconnect L.P. gas cylinder: the valve, hand tighten the nut 1. Turn the burner valves off. clockwise to a complete stop. Do not use a wrench to tighten. Use of a 2.
LEAK TESTING GENERAL Only those parts recommended by the manufacturer should be used on the grill. Although all gas connections on the grill are leak tested at the factory prior to shipment, a Substitution will void the warranty. Do not use complete gas tightness check must be the grill until all connections have been performed at the installation site due to...
Page 17
CAUTIONS Place dust cap on cylinder valve outlet where the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. The gas must be turned off at the supply cylinder when the unit is not in use.
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND WARNING: IMPORTANT! ROTISSERIE USING THE SIDE BURNER: Each main burner is rated at 10,000 Inspect the gas supply hose prior to Btu/hr. The main grill burners encompass turning the gas “ON”. If there is evidence the entire cooking area and are side of cuts, wear or abrasion, it must be ported to minimize blockage from falling...
OPERATING INSTRUCTIONS CAUTION: PLEASE TAKE OFF THE WARMING RACK WHEN USING THE ROTIS BURNER. THE HIGH HEAT COMING FROM THE ROTIS BURNER MAY CAUSE THE WARMING RACK TO BEND. GRILL LIGHTING INSTRUCTIONS Never substitute regulators and hose assembly for those supplied with the grill. WARNING: IMPORTANT! If a replacement is necessary, contact the BEFORE LIGHTING…...
Page 20
GRILL LIGHTING INSTRUCTIONS TO LIGHT THE GRILL BURNER: If you’ve just attempted to light the burner with the igniter, allow 5 minutes for any Make sure all knobs are “OFF” then turn on accumulated gas to dissipate. Keep your the gas supply from the LP tank. Always face and hands as far away from the grill keep your face and body as far from the as possible.
Page 22
GRILL LIGHTING INSTRUCTIONS FLAME CHARACTERISTICS flame is noisy and tends to lift away from the burner, it indicates too much air. Check for proper burner flame characteristics. Burner flames should be blue and stable Each burner is adjusted prior to with no yellow tips, excessive noise, or shipment;...
LIGHTING ILLUSTRATION Main & Side Burner Lighting Illustration Rotisserie Burner or Searing Burner Lighting Illustration Step 1. Step to light the Rotisserie Burner : Make sure the Lid is open Push and turn the rotisserie knob to “ON” position and hold down for 3-4 seconds then push electronic ignition button at the same time, until burner is lit.
Please note the chart below to give an easy reference for the various orifice opening sizes for the different valves in the grill. Orifice Sizes and BTU Ratings Model No. 720-0193 Components Orifice Size Orifice Size Main Burner 0.94 mm...
Page 25
INSTRUCTIONS FOR CONVERTING TO NATURAL GAS TOOLS NEEDED: A- 9mm & 7mm LONG SOCKET & DRIVER B-PHILLIPS & C-FLAT-HEAD SCREWDRIVER D-ADJUSTABLE WRENCH E-10mm OPEN END WRENCH F-VICE GRIPS Step 1: Replace Main Burner Orifice a. Remove cooking-grids & flame tamers b.
Page 26
Gas Conversion Step 2:Replace Side Burner Orifice a. Remove side burner cooking grid & burner b. Locate & Replace side burner orifice using a 7mm socket(refer to below illustration) c. Replace burner side burner & grid Step 3: Replace Rear Burner Orifice a.
Page 27
Gas Conversion Step 4: Replace Sear Burner Orifice a. Remove the thermocouple cover at back of fire-box, then remove the thermocouple. Remove the COTTER-PIN under Searing burner and remove the burner b. Locate LP-Orifice (inside front wall of firebox) & and use 9mm long socket to replace with NG-Orifice c.
Page 28
Gas Conversion Step 5: Adjustment of Control Valves for Main Burner, Side burner. a Remove all control-knobs with 5/32” Allen wrench (provided) b. Adjust gas valve through access hole at knob-bezel by inserting a flat head screw-driver. Turn the screw driver clockwise (to tighten) until it stops. (Not: it may already be fully turned so it will not turn further).
Page 29
CARE AND MAINTENANCE STAINLESS STEEL MAIN GRILL BURNER CLEANING The grill is made from non-rusting and Ensure the gas supply is off and the knobs non-magnetic stainless steel. There are are in the “OFF” position. Make sure the grill many different stainless steel cleaners is cool.
CARE AND MAINTENANCE HOW TO REPLACE MAIN BURNER STAINLESS STEEL : Step 1. Locate the burner onto the orifice. There are many different stainless steel cleaners available. Always use the mildest cleaning procedure first, scrubbing in the direction of the grain. Do not use steel wool as it will scratch the surface.
TROUBLE SHOOTING SPIDER AND INSECT WARNING!!! WHEN TO LOOK FOR SPIDERS Spiders and small insects occasionally You should inspect the burners at least spin webs or make nests in the grill burner once a year or immediately after any of the tubes during transit and warehousing.
Page 32
TROUBLE SHOOTING CHECK LIST WHAT TO DO PROBLEMS Check to see if LP tank is empty. Grill won’t light when the control knob is rotated. Clean wire(s) and /or electrode by rubbing with alcohol and clean swab. Wipe with dry cloth. Make sure the wire is connected to electrode assembly.
Page 34
PARTS LIST DESCRIPTION Q’TY DESCRIPTION Q’TY Main Lid Knob Bezel Temperature gauge Control Knob Heat Insulation Gasket Ignition Button Main Lid Handle Grease Tray Lid-Side Burner Handle Grease Tray Grid-Side Burner Left Push-Bar Side Burner Cap Left Front C-Panel Brass Ring-Side Burner Left Panel Side Burner Tank Retention bolt...
Page 35
PARTS LIST DESCRIPTION Q’TY DESCRIPTION Q’TY REF# REF# Bowl Assembly Caster Rear baffle Caster W/O Brake Cooking Grid W/hole Bottom Panel Cooking Grid W/o hole NG orifices Pack Warming Rack PU Cover Flame Tamer Manual Gas Collector Key Washer Shaft Collar Rotisserie Rod Counter Balance Spit-Fork Rotisserie...
ORDERING PARTS IMPORTANT REPLACEMENT HOW TO ORDER PARTS Use only factory authorized parts. The use of any part that is not factory authorized To make sure you obtain the correct can be dangerous. This will also void your replacement part(s) for your gas grill, warranty.
GRILL COOKING CHART WEIGHT OR APPROXIMATE SPECIAL INSTRUCTIONS AND FOOD THICKNESS FLAME SIZE TIME TIPS VEGETABLES Slice.Dot with butter or margarine Wrap in heavy-duty foil.Grill,turning occasionally Fresh Beets Medium 12 to 20 minutes Carrots Grill,turning once.Brush Occasionally Turnips With melted butter or margarine Onion 1/2 inch slices Medium...
Page 38
GRILL COOKING CHART WEIGHT OR APPROXIMATE SPECIAL INSTRUCTIONS FOOD THICKNESS FLAME SIZE TIME AND TIPS Tenderloin, Porterhouse, Remove excess fat from edge. Slash T-Bone, Sirloin remaining fat at 2-inch intervals. Rare 1 inch High 8 to 14 minutes Grill, turning once. 1-1/2 inch High 11 to 18 minutes...
Page 39
GRILL COOKING CHART WEIGHT OR APPROXIMATE SPECIAL INSTRUCTIONS FLAME SIZE FOOD THICKNESS TIME AND TIPS FISH AND SEAFOOD Grill,turning once.Brush with melted butter,margarine or oil Steaks To keep moist. Halibut 3/4 to 1 inch Medium to 8 to 15 minutes Salmon High Swordfish...
GRILL RECIPE SUGGESTIONS BBQ SALMON TANGY SEAFOOD KABOBS Half hour before cooking, turn the burner to the grill on full. Drain 1 lb. Large shrimp, shelled & 2 large salmon steaks deveined seafood reserving marinade. On 2 tbs. Oil each of twelve 10” skewers, ¾...
Page 41
GRILL RECIPE SUGGESTIONS Preheat grill. Combine cheese, Pound flank steak to ¼ inch In blender, process 1/3 c. water, condensed soup, milk, BBQ thickness or flatten chicken onion, soy sauce, 2 tsp. oil and sauce, oregano, salt and pepper breasts. Mix oil, lime juice and the next 8 ingredients until in a large mixing bowl.
Page 42
GRILL RECIPE SUGGESTIONS CHICKEN TANDOORI STYLE Marinade ribs for 3 hours. Use TURKEY marinade for basting by adding 8 large chicken thighs or 12 lb. turkey drumsticks beer to it. Place pan under the Beer basting sauce: ribs and baste frequently. To 1 c.
LIMITED WARRANTY LIMITED WARRANTY MODEL 720-0193 STAINLESS STEEL OUTDOOR GAS GRILL Nexgrill Industries, Inc. warrants to the original consumer purchaser of each Outdoor Gas Grill that when subject to normal residential use, it is free from defects in workmanship and materials for the periods specified below. This warranty excludes grills used in rental or commercial applications.