Installing The White Knob Assembly; Note On Service; Information Of The Software Version; Description On Backup Battery - Sony RM-B750 User Manual

1-9-2. Installing the WHITE Knob Assembly

n
The two WHITE knob assemblies can be replace in the
same way.
1. Rotate the shaft of the WHITE knob fully and stop
rotation at the position that generates the clicking
sound.
2. Install the WHITE knob assembly while aligning the
white mark of it with the corresponding mark of the
operation panel.
WHITE knob assemblies
Shaft of the WHITE knob
RM-B750

1-10. Note on Service

1-10-1. Information of the Software Version

There are the following Camcorder models to which this
unit can be connected:
Model
HDW-700/700A series Ver.1.00 or later
HDW-F900 series
HDW-750/730 series
MSW-900 series
DVW-707/709WS/
790WS series
*
No
White mark

1-10-2. Description on Backup Battery

w
The lithium battery is a critical part to safe operation.
Replace the component with Sony part whose part number
is listed in the manual published by Sony.
If the component is replaced by any part other than the
specified ones, this may cause a fire or electric shock.
c
When replacing the lithium battery, ensure that the battery
is installed with + and _ poles connected to the correct
terminals. An incorrect connection may cause an explosion
or leakage of fluid as a result, physical damage in the
Mark on the
surrounding materials may be caused.
operation panel
A lithium battery on the MPU-124 board is used to back up
the date data to be stored in the memory stick. Reset the
date data using he RM configuration menu is the Maintenance
menu (Refer to the operation manual "Initial Settings".)
after replacing the MPU-124 board or the dead battery.
Replacement part : BT1 (MPU-124 board)
DescriptiWon :
Parts number :
Recommended replacement period : Every 7 years
m
. When replacing the MPU-124 board, it is recommended
to replace the battery at the same time.
. Resetting the date data is required also when the battery
is removed from the battery holder.
1-9. Installing the IRIS Knob Assembly and WHITE Knob Assembly
Software
Ver.1.00 or later
Ver.1.50 or later
Ver.1.60 or later
Ver.1.19 or later
: Data writing to the memory stick in the camera is possible.
CR-2032 (Lithium battery)
! 1-528-174-31
1-10. Note on Service
File writing to
Memory Stick
in this unit
No
Yes
No *
No *
No
1-9 (E)