Table of Contents
Advertisement
Setting Up the Remote . ^.
Commander
Before you can start using the Remote Commander, you must
first set it up. This booklet describes everything you need to
know to set up the Remote Commander, including:
Installing the batteries (instructions are on page 5)
Presetting the Remote Commander with the codes for your
TV, VCR, MDP and cable box (instructions begin on page 6)
About Presetting the Remote Commander .
To set up this Remote Commander to use with other (non-
Sony) manufacturer's TVs, VCRs, MDPs and cable boxes,
you'll need to follow the instructions in this booklet to preset
the Remote Commander with the correct code number.^ „^^^
Note:
The Remote Commander can be set up to operate up to two
components (DSS®, TV, cable box) at a time — unless their
code numbers happen to be the same. For example, you can set
up the Remote Commander to operate two TVs by setting their
codes into the FUNCTION buttons—CABLE and TV. For VCR
and MDP operation, the Remote Commander can be set up to
operate up to four components (VCR, MDP) by switching the
slide switch inside the Remote Convmander's hd.
.
^^
Installing the Batteries
Slide open the battery compartment and insert two size AA
batteries (not supplied). Be sure to line up the + and - on
the batteries with the + and - on the battery compartment.
Notes on Batteries
Under normal conditions, batteries will last up to six
months. If the Remote Commander does not operate
properly or the indicators of the buttons on the Remote
Commander do not light up, the batteries may be worn out.
When replacing batteries, replace both of them with new
ones.
Do not mix old batteries with new ones or mix different
types of batteries together.
Whenever you remove the batteries — to replace them, for
example — the code numbers revert to the factory settings
and must be reset.
If the electrolyte inside the battery should leak, wipe the
contaminated area of the battery compartment with a cloth
and replace the old batteries with new ones. To prevent the
electrolyte from leaking, remove the batteries when you
don't plan to use the Remote Commander for a long period
of time.
Advertisement
Table of Contents
