Changing The Turn Signal Bulb - KTM 990 Adventure EU Owner's Manual

ELECTRICAL SYSTEM

Changing the turn signal bulb

13.12
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Pull socket
–
Insert the new bulb into the socket and insert the socket into the headlight.
Parking light (W5W / socket W2.1x9.5d) (
–
Install the headlight mask with the headlight. (
100596-10
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb

it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
100597-10
Turn signal (RY10W / socket BAU15s) (
out of the headlight and pull bulb

.

carefully into the socket, turn it counterclockwise by about 30°, and pull
out of the socket.

p. 192)
p. 134)
p. 192)
137