Installing Position Of The Needle Clamp; Adjusting The Length Of The Lower Looper Holder (Applicable Only To Mo-6716D Series) - JUKI MO-6700D Series Manual

(3) Installing position of the needle clamp

Needle clamp connecting stud
mm.

(4) Adjusting the length of the lower looper holder (Applicable only to MO-6716D series)

The center-to-center distance should be 26 mm.
At this time, the clearance between the end surface of the arm and the neck of the ball should be 3.5mm.
Standard Adjustment
should fit with the bottom end of needle bar
Butt the needle clamp with the
bottom end of the needle bar.
Standard Adjustment
26mm
3.5mm
– 6 –
or be spaced within 0 to 0.5