Inserting The Car Radio - Medion MD 81485 Manual

CarRadio MD 81485_AUS.fm Seite 10 Donnerstag, 17. August 2006 7:50 07
Installation
Test station memory
In some vehicle models the standard arrangement for the
standard plus and permanent plus cables has been switched in
the factory (see"Arrangement of the ISO block" on page 13). This
can lead to the station memory not working.
Before you finally install the car radio, try the following to find out if you have
saved the stations.
• Reconnect the car battery.
• Turn on the ignition.
• Switch the radio on.
• Go through the automatic station saving process, holding down the A/PS/SCH
[8]key for approx. two seconds (see also"Automatic saving" on page 16).
• Switch the ignition off.
• Switch on the ignition again and find out if the stations have been saved (press
the station buttons 1 bis 6 [12-17]).
• If the stations have been saved, you can install the radio.
• If the stations are no longer in the memory, you should use an adapter,
obtainable from the specialist store, or have the cable adapted in a specialist
garage. If this is the case, refer to Chapter "Explanation for using the cables"
on page 12.

Inserting the car radio

• Push the car radio carefully into the slot until it
clicks into place.
While pushing the radio in, be careful how you fit
the cables; they should not be kinked, crushed or
stretched.
10