Using The Car Radio - Medion P62033 Instruction Manual

Before finally inserting the car radio, use the following procedure to check whether
the stations stay saved:
 Reconnect the car battery.
 Switch the vehicle's ignition on.
 Switch the radio on.
 Save stations automatically by holding down the AS/PS button for around two
seconds (see also "Automatic search for the 6 strongest stations (APS)" on page
72).
 Switch the vehicle's ignition off.
 Switch the ignition on again and test whether the stations are still saved (to do
so press the station buttons 1 to 6).
 If the stations have been saved you can insert the radio.
 If the stations are no longer saved, you should use an adapter, available from
specialist retailers, or arrange for a specialist workshop to modify the cables. In
this case, please observe the information in chapter "8. Information on the ca-
bles" on page 64.
6.5.

Using the car radio

 Push the car radio carefully into the slot until it clicks into place.
NOTE!
When inserting the radio, make sure that the cables are not kinked,
squashed or pulled tight.
 Then put the cover frame on the radio.
62 of 86
84003 DE EN eCommerce Content final REV4.indb 62 84003 DE EN eCommerce Content final REV4.indb 62 28.05.2015 09:09:08 28.05.2015 09:09:08