Cable Connections - Medion MD 81485 Manual

CarRadio MD 81485_AUS.fm Seite 9 Donnerstag, 17. August 2006 7:50 07

Cable connections

A general view of the back of the car radio:
Connect up the cables
• Pull out the connections in your car's ISO slot far enough for you to join them
to the ones from the car radio.
Please use the car radio's ISO block for installation. Never disconnect the ISO
block If your car's ISO plugs do not fit the car radio's ISO sockets, you can buy
suitable adapters in specialist garages, from dealers and the specialist
departments of large stores.
Secure, proper electrical connections are provided by your car' s two ISO
plugs (for the loudspeakers and the power connections). In case you still
wish to lay the cables yourself, we explain in detail the uses of the cables
at the end of this chapter.
[A] Connect the vehicle's antenna plug to the radio's antenna socket.
[B] If you use an external amplifier, you can connect it to the red/white RCA
audio sockets. Please also refer to your instructions for the amplifier.
[C] Connect the vehicle's two ISO plugs (one ISO plug for ISO Block A and one
for ISO Block B) to the car radio's ISO block.
MD 81485
Installation
9