JVC CX-7000 Series Electronic Manual page 89

[Printing area] Dialog Box
Settings related to the printing area using the peel-off ink or areas not
to be printed using all YMCKUV inks.
.
X=0
Y=0
H
About Y=56.0
.
Rectangular region
Printing area information.
X
X coordinate that indicates the start of the area. (Unit: mm).
Y
Y coordinate that indicates the start of the area. (Unit: mm).
W
Width of the printing area. (Unit: mm).
H
Height of the printing area. (Unit: mm).
Ink
Ink valid for the printing area.
1. Peeloff:
Area for printing using the peel-off ink.
2. YMCK:
Area not to be printed using all YMCKUV inks.
Side
The side of the card for which the printing area is valid.
1. Front:
Front side
2. Back:
Back side
About X=87.5
W
Direction of card
movement
[Add] button
Registers the input data. You can enter up to 8 input data.
[Delete] button
Deletes the information selected in the list.
[Delete All] button
Deletes all registered information.
Peeloff ink energy
Print density of the peel-off ink.
Do not alter the following values.
E1: 225
E2: 160
E3: 160
Setting values
The following requirements must be satisfied.
E1
E1
E2
E3
.
The following values are recommended when peel-off printing is
performed on the ISO magnetic stripe area of the card.
X Y W H
0 0 87.46 17.86
0 0 87.46 21.42
Cautions:
The input value of the textbox may differ from the value of the
"Printing area information" portion by an accidental error in
calculation.
Memo:
The printing start position displayed on the application software may
not coincide with the X=0, Y=0 position above.
About 1 mm from the edge of the image is not printed on the card.
"The edge of the image is not printed" (A page 123)
> = > =
E2 E3
Ink Side
1. Peeloff 1. Front
2. YMCK 1. Front
Setup
89