JVC CX-7000 Series Electronic Manual page 24

Operating the Printer
Firmware Update
1
Press I
A [Cleaning] message appears.
.
2
Press J to set to [Download]
Pressing it each time displays the next setting item.
.
3
Press G
A [Download Ready] message appears, indicating that the printer is
ready to download data from the computer.
.
.
4
Start data download from the computer
A [Downloading..] message appears.
.
Cautions:
Do not turn off the power during data download from the computer.
Doing so may damage the printer firmware and cause malfunction.
A [Download Ready] message appears when data download from
the computer is complete.
.
5
When [Download Ready] appears, press H
6
When the [Please Power Off] message appears, turn off the power
The firmware is updated after the power is turned on again.
24
If download fails and printer cannot be started up
If download of the printer firmware fails, the printer may not be
able to start up when it is rebooted. When this occurs, download
the firmware again according the following procedure.
A Turn on the power while holding down the operation button
(center)
A [SBP2 Running] message appears, indicating that the printer
is ready to download data from the computer.
.
B Start data download from the computer
A [Downloading..] message appears.
A [SBP2 Running] message appears when data download from
the computer is complete.
C When the [SBP2 Running] message appears, turn off the power
The firmware is updated after the power is turned on again.