List Of Error Codes - JVC CX-7000 Series Electronic Manual

Setup

List of Error Codes

Printer (Error Code:0x01000000-0x01040000)
No. Error Code
1 0x0102D000 Cards have run out.
The card hopper is detached.
2 0x0102D100 The printer door is open.
The cleaning unit is detached.
3 0x0102D300 The printer is busy.
0x0102D400
0x0102D500
4 0x0102DA00 Preheating is in progress.
5 0x0102DB00 Printer is initializing.
6 0x0102DC00 Offline testing is in progress.
Cleaning is in progress.
7 0x0102DD00 Operation panel is currently in use.
The printer is in the transport mode.
8 0x0102DE00 The firmware cannot be downloaded.
9 0x0102FD00 The printer is in the Power Saving mode.
10 0x0102FE00 Password authentication is not complete.
11 The printer is not ready.
0x0102RRRR
12 0x01039000 Failure occurred during card loading.
13 0x01039100 Card jam near the card turn over unit.
14 0x01039200 Card jam near the magnetic encoder.
15 0x01039300 Card jam near the card feed roller.
16 0x01039400 Card jam near the card outlet.
17 0x01039500 Card jam near the retransfer heating roller.
18 0x0103A100 Retransfer film is broken.
Retransfer film is not detected.
19 0x0103A800 A writing error has occurred during magnetic
encoder self-diagnosis.
20 0x0103AD00 An error has occurred during magnetic encoding
data writing.
21 0x0103AE00 An error has occurred during magnetic encoding
data reading.
22 0x0103B000 An incorrect ink ribbon is installed.
23 0x0103B100 Ink ribbon is broken.
Ink ribbon is not detected.
24 A media error has occurred.
0x0103RRRR
120
Description Actions (Reference Page No.)
Replenish the cards. (A page 31)
Install the card hopper. (A page 63)
Close the door, and press K N B to reset the printer.(A page
22)
Install the cleaning unit. (A page 35)
-
Wait until preheating is complete.
Wait until initialization is complete.
Wait until the offline test is complete.
Wait until cleaning is complete.
-
Cancel the transport mode. (A page 29)
Set the printer to the download mode. (A page 24)
Resetting the printer temporarily cancels the Power Saving mode. (A
page 22)
The printer resets automatically when the printer driver is used to start
printing.
-
-
Remove the card according to the procedure for the "Error Code: Jam
(Hopper) 90". (A page 46)
Remove the card according to the procedure for the "Error Code:
Jam(TurnOver) 91". (A page 47)
Remove the card according to the procedure for the "Error Code: Jam
(MG) 92". (A page 49)
Remove the card according to the procedure for the "Error Code: Jam
(Transfer) 93". (A page 50)
Remove the card according to the procedure for the "Error Code: Jam
(Discharge) 94". (A page 51)
Remove the card according to the procedure for the "Error Code: Jam
(Retran.) 95". (A page 52)
Repair the retransfer film. (A page 56)
Install the retransfer film correctly. (A page 61)
Check the card specifications.
Install a correct ink ribbon.
Repair the ink ribbon. (A page 54)
Install the ink ribbon correctly. (A page 60)
Check the card specifications.