Sony TRINITRON KD-34XBR2 Service Manual page 27

9. Converge the vertical lines at the sides of the screen.
Device Name Adj. Item #
D-CONV 3
D-CONV 6
LSAP affects the
left side.
If the side horizontal convergence can't be
achieved, the neck assembly may be too far
forward or too far rearward. Refer to the
Mechanical Pre-adjustments section.
10. Write the data to memory.
11. Remove the bow from the right and left side top and bottom of the
vertical lines in the cross-hatch pattern.
Device Name Adj. Item #
D-CONV 4
D-CONV 5
D-CONV 7
D-CONV 8
* Adjust as necessary to minimize the bow (separation).
Name Data
RSAP *
LSAP *
RSAP affects the
right side.
Name Data
RUBW *
RLBW *
LUBW *
LLBW *
LUBW affects this
corner.
LLBW affects this
corner.
12. Write the data to memory.
13. Check the convergence in the ZOOM, WIDE ZOOM, and HD1080i
modes. Only minor touchups are allowed, as they affect the other
modes. Make minor adjustments as necessary as described in the
sections 5.7 to 5.12.
14. Copy the FULL mode convergence adjustments to the normal mode
as follows:
a) Select adjustment category "D-CONV".
b) Select adjustment item # 10 "COPY 2".
c) Change the data from "0" to "1".
d) Press "MUTING" and then press "ENTER".
15. Select the NORMAL mode.
16. Adjust the NORMAL mode convergence as described in items 7 to
12.
This completes the dynamic convergence adjustment.
— 27 —
KD-34XBR2
RUBW affects
this corner.
RUBW affects
this corner.