Connect To Ilom And Configure An Ip Address - Sun Microsystems Sun Fire X4170 Getting Started Manual

4. Connect the power cords to AC power connectors and, to enhance redundancy, to separate power sources.
When power is applied, the SP initializes and the Power/OK LED flashes (
few minutes, the SP Login prompt appears on the terminal device. Note that the server is not initialized or
powered on yet. For more information on connectivity options, refer to the Sun Fire X4170, X4270, and X4275
Servers Installation Guide.
At this point, standby power is supplied only to the service processor and power supply fans. Do not apply
main power to the rest of the server until you are ready to install a platform operating system. In standby
power mode, the Power/OK LED on the server's front panel flashes. (
Server. Sun Fire X4270 Server front panel controls are at the same location as Sun Fire X4170 controls.
shows the Sun Fire X4275 Server.)
FIGURE 3
Sun Fire X4170 Server Front Panel Controls
FIGURE 2
1
Figure Legend
1 Power/OK LED
Sun Fire X4275 Server Front Panel Controls
FIGURE 3
1
Figure Legend
1 Power Button
▼ Connect to ILOM and Configure an IP Address
There are three methods for connecting to the Integrated Lights Out Manager (ILOM) SP to perform initial setup
and configure an IP address:
Connect to ILOM using a serial connection
■
Connect to ILOM using an Ethernet connection (DHCP)
■
Connect to ILOM using an Ethernet connection (static IP address)
■
2
2
FIGURE 2
2 Power Button
2 Power/OK LED
3
and ). After a
FIGURE 2 FIGURE 3
shows the Sun Fire X4170