Sony DCR-TRV240 Service Manual page 109

DCR-TRV240/TRV340
1-2. INITIALIZATION OF 8, A, B, C, D, E, F, 1B, 1C,
1F PAGE DATA
Note1: When reading or writing the 1B, 1C, 1D page data, select page: 0,
address: 10, and set data: 01, then select B, C or D page. The 1B.
1C or 1D page can be chosen by this data setting.
After reading or writing, reset the data of page: 0, address: 10 to
"00".
Note2: The A, B and 1B page are DCR-TRV340 model only.
[Connection of the power supply during the initialization
of the data.]
1) Connect the regulated power supply and the digital voltmeter
to the battery terminal as shown in Fig. 5-1-6.
2) Adjust the output voltage of the regulated power supply so that
the digital voltmeter display is 6.1 ± 0.1Vdc.
3) Turn off the power supply.
4) Turn on the HOLD switch of the adjusting remote commander.
5) Turn on the power supply.
6) Perform the initialization of the data.
Note3: This is normal though the following message is indicated on the
LCD screen.
"FOR InfoLITHIUM BATTERY ONLY"
Digital voltmeter
Regulated power supply
[Initialization Procedure]
DCR-TRV240 :
1. Initialization of D page data
2. Initialization of 8, C, 1C page data
3. Initialization of E, F, 1F page data
DCR-TRV340 :
1. Initialization of A, D page data
2. Initialization of B, 1B page data
3. Initialization of 8, C, 1C page data
4. Initialization of E, F, 1F page data
Battery terminal
Fig. 5-1-6.
5-8