Brush Removal & Large Belt Replacement - WERTHEIM SE9000 Instruction Manual

BRUSH REMOVAL & LARGE BELT REPLACEMENT
Brushes can be removed for cleaning or replacement as needed.
1. Follow small belt removal Instructions on page 18.
2. Remove brush rolls by pulling them off of the metal rods.
3. Place cleaned or new brush rolls back onto the rods. Make sure one washer is on each
end of the rollers prior to sliding onto the rod. Be sure to let the rod slide through the
bushing to insure proper fi t.
4. Re-attach the long belt on the bottom to the cogs of the small roller brushes.
5. Place small belt over back roller and metal cog.
6. Place pivot arm in place and screw in place using the silver screw.
7. Re-attach clear end cap by tightening with the (2) black screws.
8. Return front nozzle to front of unit, by latching from underneath and then securing
with a screw.
8
2
5
9
3
6
4
7
19