WERTHEIM SE9000 Instruction Manual page 11

10. Set ReadyTools dial to the fl oor cleaning setting.
11. Plug into a proper outlet and turn the power and heater switches to the ON ( I ) position.
Allow 1 minute for the built-in heater to warm-up before cleaning. The SE9000 will be
fully warmed and will provide optimal performance after one minute of continuous
heated cleaning.
12. Cleaning strokes. While pressing the spray trigger, make one slow forward wet pass and
another one back. Let the built-in heater, formula, and DirtLifter PowerBrushes do the
work for you.
CAUTION: Do not over-wet. Take care not to run over loose objects or edges of area rugs.
Stalling brush may result in premature belt failure.
NOTE: Your machine is equipped with a circuit breaker that will automatically shut off the
brush if a large or loose object is caught in the brush roll. If that happens, be sure to unplug
your machine, remove the foreign object, and then plug the machine back in to reset the
circuit breaker. Release the spray trigger and make one slow forward and backward pass over
the same area to remove any residual dirty water and aid in drying. Repeat cleaning passes
until solution being pulled up appears clean. Continue passes without pressing the spray trigger
until you can't see any more water being pulled up.
13. After cleaning, you may want to turn the Custom Clean dial to rinse to give your carpeting
a fi nal water only rinse. This will ensure thorough removal of embedded dirt loosened by
the deep cleaning formula. Wertheim deep cleaning formulas contain an anti-resoiling
agent that helps your carpets repel dirt and keeps them looking good longer.
14. Remove the tank from the base of the machine by lifting up on the tank carry handle. Carry
like a bucket to a utility sink or outside where you will dispose of the dirty water.
15. Unlatch the top of the tank from the bottom by lifting up on the tank latch which is
located on the back of the tank.
16. Remove the top of the tank by lifting up on the handle. Note how the lip on the top tank
separates from the groove in the bottom tank. This placement is important when putting
the tank back together.
FLOOR
CLEANING
10
Power Switch Heater Switch
11 14
11