Maintenance & Care; Machine Storage; Machine Care - WERTHEIM SE9000 Instruction Manual

MAINTENANCE & CARE MAINTENANCE & CARE

MACHINE STORAGE

Once your cleaning is complete, make sure the 2-in-1 water tank is emptied, rinsed out, and
dried before the next use. The formula tank can remain fi lled and ready to go, or it can simply
be emptied back into the formula bottle if that is more convenient.
NOTE: Store cleaner in a protected, dry area. Since this product uses water, it must not be
stored where there is a danger of freezing. Freezing will damage internal components and void
the warranty.
To reduce the risk of fi re, electric shock or injury unplug from outlet before servicing.

MACHINE CARE

For best results, a few simple steps can assure your machine is well maintained after your
cleaning is complete.
1. Turn power and heater switches OFF ( O ). Unplug the machine and wrap the power cord.
2. After emptying the 2-in-1 water tank, rinse it out at a faucet with running hot tap water,
taking care to clean underneath the heavy duty bladder, and all around it.
3. The top half of the tank can be rinsed clean through the nozzle area. Also, pop out the red
fi lter underneath the top half of the tank and rinse that out. Replace before putting the
top and bottom halves of the tank together.
4. Before you place the cleaned 2-in-1 water tank back onto the machine, simply unscrew the
fl oor nozzle using a Phillips head screwdriver. This can be rinsed out at the faucet. Then
replace back onto the machine by starting from the bottom of the nozzle and hooking the
tabs into the holes on the bottom sides of the machine. Secure into place with the screw.
5. The inside of the end caps by the brush rolls can be wiped out with a clean paper towel, or,
if a more thorough cleaning is desired, the end caps can be taken off using a Phillips head
screwdriver and rinsed clean. Replace after cleaning.
6. Any loose hair or debris can be pulled from the brush rolls and thrown away. For the
most thorough clean before storage, follow directions on pages 18 & 19 for removal and
replacement of the brush rolls and belts.
7. To clean attachments that may have been used, remove from hose and rinse in clean,
running water. Dry and replace attachment in the tool caddy. Clean the hose by suctioning
clean water from the tap. Before replacing, lift end of hose and stretch out to ensure all
water is cleared from hose. Refer to page 14, instructions 9 & 10.
8. After carpet is dry, vacuum again to remove hair and fuzz.
WARNING
3
17