WERTHEIM SE9000 Instruction Manual page 12

17. Lift the bottom portion of the tank; pour out dirty water toward the sink through the
triangular shaped opening in the corner of the tank. Note: You may notice hair & debris
deposits on the carpet or in the tank that were loosened by the cleaning action (especially
with newer carpets that have never been deep cleaned before). This debris should be
picked up and thrown away.
18. Fill the heavy duty bladder with hand warm (40°C) tap water, following instructions 4
through 6 on page 10. Note: Remember to secure the tank latch in the back and test
to make sure it is secure before picking up the tank. Always check the level of cleaning
formula in the formula tank at the same time, and refi ll as needed.
19. Water rinse (optional). Rinsing is an optional step that can be done during the cleaning
process by switching from one of the clean settings on the Custom Clean dial to a water
rinse setting, or it can be done after the carpeted area has been cleaned. Simply choose
the water rinse setting on the Custom Clean dial, and follow the same path as you did
for cleaning, taking care to do a forward (wet) stroke by depressing the spray trigger,
a backward (wet) stroke, and a forward and backward (dry) stroke, releasing the spray
trigger. Continue this until the water you see coming up the nozzle is clear.
20. CleanShot. CleanShot is an optional feature that can be used to fi ght tough stains. It can
be used as either a tough stain precleaner (see page 9) or can be used during the deep
cleaning process itself. To use CleanShot either as a precleaner or during deep cleaning,
follow the instructions below.
A. Set Custom Clean for the desired setting.
B. Press the CleanShot button and aim the focused stream onto the stain. Allow the formula
to soak in for 30 seconds.
C. Run the machine over the stain to extract. Repeat as needed until the stain is gone.
D. Rinse if desired.
15
18
12
16
19
17