Cisco 2500 Series Deployment Manual page 14

In the all of the above configuration, VLAN10 is not tagged on the switch. All traffic from the switch is
sourced to Port 1 on the controller. APs and client traffic is forwarded to the controller untagged.
APs are connected to the Catalyst switch with these switchport configurations. The switchport can either be
trunked or configured to be an access port.
Switch#sh run int gig 1/0/9
Building configuration...
Current configuration : 132 bytes
!
interface GigabitEthernet1/0/9
switchport trunk encapsulation dot1q
switchport trunk native vlan 10
switchport mode trunk
end
Switch#sh run int gig 1/0/10
Building configuration...
Current configuration : 66 bytes
!
interface GigabitEthernet1/0/10
switchport access vlan 10
end
Switch#
The AP can join the controller and the status of the AP can be verified on the controller. There are two APs
that have joined the controller and can be confirmed by checking the status in this capture:
<CISCO2504> >show ap join stats summary all
Number of APs.............................................. 2
Base Mac
00:22:90:96:69:00
ec:44:76:b9:7d:c0
<CISCO2504> >show ap summary
Number of APs.................................... 2
Global AP User Name.............................. Not Configured
Global AP Dot1x User Name........................ Not Configured
AP Name
−−−−−−−−−−−−−−−− −−−−− −−−−−−−−−−−−−−−−− −−−−−−−−−−−−−−−−− −−−−−−−−−−−−−−−−
AP0022.9090.abd3
APc47d.4f3a.e378
AP EthernetMac
00:22:90:90:ab:d3
c4:7d:4f:3a:e3:78
Slots AP Model
2 AIR−LAP1142N−A−K9 00:22:90:90:ab:d3 default location
2 AIR−CAP3502E−A−K9 c4:7d:4f:3a:e3:78 default location
AP Name
AP0022.9090.abd3
APc47d.4f3a.e378
Ethernet MAC
IP Address Status
10.10.10.103 Joined
10.10.10.105 Joined
Location