Change Device ID Tab
On this window you can change the ID of the device to one, two, three or four. This is
required to be done if you have more than one device connected. After the device is re‐
assigned, it will "disappear" from the PC for a few seconds and re‐appear as a new
device with its new ID.
This tab is also used to upgrade firmware.
Upgrading Firmware
• Click "Upgrade Firmware" then "OK".
• The PC will detect a new USB device and a driver will be automatically installed.
• The upgrade program will start. Click on "Select Firmware File" and navigate to
the UFW file. This will normally be contained in the install folder of the program.
• The firmware should download.
• After download, the device will reset. You should see "Device not found" on the
bottom line. The device should now be back in normal operating mode.
http://www.ultimarc.com
Page 9