Sensor View Check Tab
This display shows the Infra‐Red LED as seen by the sensor. Note that this shows the raw
uncalibrated display so will not correspond to cursor location on the screen.
This screen is used to check if the LED bar is in a location which can always be seen by
the gun, in all aiming directions.
This display can be used to determine why calibration is failing. You can start the
calibration process from this window. When you aim at the flashing cursor each time,
check the display as well. If the red dot is not visible, calibration will fail. You can move
the gun slightly to find which direction the error lies.
Failure to calibrate is usually caused by either being too close, or an obscured or faint
LED signal. This display will help to identify the problem.
http://www.ultimarc.com
Page 8