NOTE: If you do not have the mame.ini file in your MAME directory, you can tell MAME to
create the file populated with MAME default values by typing the following command in a
Command Prompt Window: mame -cc
MAME assigns numbers to input devices based on the Windows device ID (which
Windows assigns in order of initial connection) so you will also need to configure MAME
by assigning your AimTrak Light Guns to the correct Player 1 (and Player 2) Inputs. There
are two ways to do this:
Primary Method
1)
Launch MAME with any ROM: mame
2)
Press the Tab key (default key) to bring up the MAME Config Menu
3)
Use the Up/Down arrows (or joystick) to move the selection, and press the Enter
key (default key) to select Input (general)
4)
Use the Up/Down arrows (or joystick) to move the selection, and press the Enter
key to select Player 1 Controls
5)
Use the Up/Down arrows (or joystick) to move to the Lightgun X Analog input,
but before you select it make sure you hold the Light Gun steady and point it at
your screen.
robby
http://www.ultimarc.com
Page 12