NOTE: The gun must be held vertically during this process otherwise
it will fail.
• Hold the trigger for 5 seconds (this value can be changed, see Advanced
Setup)
• The mouse cursor will eventually start to move and come to rest,
pointing at a location near the top left corner of the screen, and begin to
flash. Aim the Light Gun at the cursor and pull the trigger again. The
timing is not important as the cursor is only an indicator. The aim is the
only important factor.
• The cursor will then point to a location near the top right corner. Aim at
the cursor and pull the trigger.
• The cursor will then point near the lower edge of the screen. Aim at this
point and pull the trigger. Note the position to aim is offset to the left of
the screen centerline.
If any of the above steps fails, the cursor will continue to point at the
required location and not advance to the next stage. If this continues to be
the case you might need to install the configuration software to diagnose the
problem (see Advanced Setup).
5) Re‐check your mouse cursor as you point the Light Gun at the screen in your
normal shooting style. The cursor should track your movements very closely.
http://www.ultimarc.com
Page 4