6)
Press the Enter key to select the Lightgun X Analog menu item and move your
AimTrak Light Gun steadily to the right, in a horizontal motion.
7)
This should assign "GUN # X" to the Lightgun X Analog input where # is the
number assigned to your AimTrak by MAME. If "GUN # X or GUN # Y" is assigned
instead, try again but keep the motion of the Light Gun as horizontal as possible.
Move the menu selection up then down again to Lightgun X Analog and repeat
step 6. If you are still having difficulty, try the Alternate Method below.
8)
Repeat steps 5 and 6 for the Lightgun Y Analog input, using a vertical movement
instead of horizontal.
9)
The Analog Dec and Analog Inc inputs can be assigned to "None" for both X and
Y. Do this by selecting them (Enter key) and then pressing Escape.
10) If you have two AimTrak Light Guns installed, repeat steps 4 through 9 above with
your second Light Gun, selecting Player 2 Controls instead in step 4.
11) Move the menu up to P1 Button 1. This should be assigned by default as shown:
The AimTrak Light Gun trigger will be seen by MAME as "Joy # Button 0", but it
may not be "Joy 1 Button 0" as in the default.
12) Press the Enter key to select P1 Button 1 and then press the trigger on the
AimTrak Light Gun.
NOTE: The trigger can be assigned to different buttons when aimed on and off
the screen. Make sure you point the Light Gun at the screen when you assign this
input.
http://www.ultimarc.com
Page 13