PowerStar SMX2000RMLV2U Operation Manual page 14

Function Factory Default Options
Turn Off Delay 90 sec
Reboot Duration 8 sec
Minimum Return 0 sec
Time
Load Shed On Disabled
Battery
Load Shed Time Disabled
when On Battery
Load Shed On Disabled
Runtime
Load Shed On Disabled
Runtime
Remaining
Load Shed on Disabled
Overload
Network Management Card Settings
These settings are available only on units that have a Network Management Card (NMC).
• NMC IP Address Mode
• NMC Default Gateway
12
Set the value in
seconds
Set the value in
seconds
Set the value in
seconds
• Shutdown with
Delay
• Shutdown
immediately
• Turn off
immediately
• Turn off with delay
• Disabled
Set the value in
seconds
• Shutdown with
delay
• Shutdown
immediately
• Turn off
immediately
• Turn off with delay
• Disabled
Set the value in
seconds
• Disabled
• Enabled
Smart-UPS X-Series 2000/2200/3000 VA Operation
Description
The amount of time that the Switched Outlet
Groups will wait between receiving the command
to turn off and the actual shut down.
The amount of time that the Switched Outlet
Groups must remain off before it will restart.
The amount of battery runtime that must be
available before the Switched Outlet Groups will
turn on again after a shutdown.
When the unit switches to battery power, the UPS
can disconnect power to the Switched Outlet
Groups to save runtime.
Configure this delay time, use the
setting.
T O B
IME WHEN N ATTERY
The amount of time the outlets will function on
battery power before they will turn off.
Configure this time using the
setting.
R R
UNTIME EMAINING
When the remaining runtime reaches this level,
the Switched Outlet Groups will turn off.
In the event of an overload (greater than 105%
output), the Switched Outlet Groups will
immediately turn off to conserve power for
critical loads. The Switched Outlet Groups will
only turn on again with a manual command.
L S
OAD HED
L S
OAD HED