Rules; General Information; Programming Rules - Honeywell LYNX TouchL5200 Series Manual

Home Automation

Rules

General Information

Up to 40 rules can be programmed. Rules 1 through 20 are used for Triggers, Z-Wave Scenes and Follow-Me
Messages. Rules 21 through 40 are used for Z-Wave Scenes and for E-mail notification but are only accessible
through TotalConnect Service. Check with your Installer to see which options are available to you.
The following options are programmed in this section:
Programming Field
Rule 1 - 20:
Name:
Type:
Action:
Start Zone Type OR Zone Type Fault:
Stop Zone Type OR Zone Type Restore:
Start System Operation OR
System Operation 1:
Stop System Operation OR
System Operation 1
Zone Number Operation:
* The displayed field is dependent upon the Type selection.

Programming Rules

Ready To Arm
1 : 2 35
PM
October 1, 2013
Security
Mostly Sunny
68 F
Feels Like 71 F
5-Day Forecast
News
Ready To Arm
Scenes
Tools
Schedules Garage door setup
Rules
Ready To Arm
Rules 1 Rules 2
New New
Rules 3 Rules 4
New New
Rules 5 Rules 6
New New
Edit
Select Rule 1 -20
Note: Rules 21-40 are only accessible through TotalConnect Service.
Name the device
Select the output type
Select the action required for the device
Select Zone Type to start event*
Select Zone Type to stop event*
Select System Operation to start event*
Select System Operation to stop event*
Select Zone Number to trigger event upon fault, trouble or alarm as selected.
Automation Video
Traffic Notices
5200-100-001-V0
5200-100-053-V0
Delete
5200-100-059-V0
1. With the system in the disarmed state, select the "Automation"
icon from the Home Screen. The system displays the first
page of the Automation screen. Select the "" icon to
advance to the second page of the Automation screen.
2. Select the "Rules" button. The system displays the Rules
screen.
3. Select a "Rules" key followed by the Edit button.
Note: Rules 21-40 are only accessible through TotalConnect
Service.
- 14 -
Action