Configuration Of Options - Toshiba E-Studio 205L Quick Start Manual

Chapter 1 PREPARATIONS

Configuration of options

For e-STUDIO205L/255/305/355/455
For e-STUDIO205L/255/305
For e-STUDIO355/455
1.
Original Cover (KA-1640PC)
This is used to hold an original.
2.
Reversing Automatic Document Feeder (MR-3021,
MR-3022)
This unit automatically feeds a stack of originals one by
one to have them copied.
Install the MR-302 in the e-STUDIO205L/255/305, and
the MR-3022 in the e-STUDIO355/55.
3.
Bridge Unit (KN-2520)
This unit acts as a relay for the Finisher and this
equipment.
4.
Job Separator (MJ-5004/MJ-5006)
Enables Faxes, copies and prints to be output onto
separate paper trays.
Install the MJ-500 in the e-STUDIO205L/255/305, and the
MJ-5006 in the e-STUDIO355/55.
5.
Offset Tray (MJ-5005)
Enables copied and printed sets to be collated or stacked
in groups with each set being offset.
6.
Paper Feed Pedestal (KD-1025)
This pedestal enables you to install the Additional Drawer
Module (optional, MY-033).
7.
Large Capacity Feeder (KD-1026)
This feeder enables you to feed up to 2000 sheets (80 g/m
or 20 lb. Bond) of A or LT paper.

10 9
12 11 13
15 14
6
8.
Additional Drawer Module (MY-1033)
This drawer can be added to the Paper Feed Pedestal
(optional, KD-025). Combined with the 2 drawers in the
equipment, paper can be fed from  drawers in total.
9.
Finisher (MJ-1101)
This Finisher enables sort/group finishing and stapling.
The Hole Punch Unit (optional, MJ-60) can be installed
in this Finisher. The Bridge Unit (optional, KN-2520) is
required for the installation of this Finisher.
10.
Saddle Stitch Finisher (MJ-1024)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(optional, MJ-600) can be installed in this Finisher. The
Bridge Unit (optional, KN-2520) is required for the
installation of this Finisher.
11.
Saddle Stitch Finisher (MJ-1025)
This Finisher enables saddle stitching, in addition to sort/
group finishing and stapling. The Hole Punch Unit
(optional, MJ-6005) can be installed in this Finisher. The
Bridge Unit (optional, KN-2520) is required for the
installation of this Finisher.
12.
Hanging Finisher (MJ-1031)
This Finisher enables sort/group finishing and stapling.
The Bridge Unit (optional, KN-2520) is required for the
installation of this Finisher.
2
1 2
3
4
5
7 8