Panasonic KX-TEB308 Features Manual page 27

UCD Intercept Mode
When extensions in a UCD group are available but do not answer an outside (CO) line call within a
preprogrammed length of time (
one of the following ways according to system programming (
a)
Disconnect: The call is disconnected. If a UCD OGM is not played, the call will not be
disconnected until the caller goes on-hook.
b)
Intercept: The call is directed to preprogrammed destinations (
Lunch [408-410]). The extensions that receive the redirected call ring for a preprogrammed time
period (
If a UCD OGM is not played, the call will not be disconnected until the caller goes on-hook.
Conditions
• To use this feature, "UCD" must be selected as the distribution method for the desired outside (CO) line
port ( CO Line Mode—Day/Night/Lunch [414-416]).
• UCD OGM
It is possible to select the UCD OGM sent to the caller when a call arrives at a UCD group and all
extensions in the group are busy (
• The Log-in or Log-out status can be set for each extension (
of a group cannot log out.
• FWD/DND Mode
When searching for an available extension, any extension that has set FWD—All Calls, FWD—Busy/
No Answer, or DND will be skipped (
• UCD Busy Waiting Time
It is possible to assign the length of time (
outside (CO) line call via the UCD feature when all extensions in the UCD group are busy, and to assign
the interval time between the repeated UCD OGMs (
Feature Guide References
1.1.1.2 Intercept Routing
1.12.4 Music on Hold
2.2.2 Group
UCD Ring Time before Intercept [525]), the PBX will handle the call in
UCD Ring Time after Intercept [526]). When the timer expires, the call is disconnected.
UCD Waiting Message [527]).
1.3.1 Call Forwarding (FWD)/Do Not Disturb (DND)).
UCD Busy Waiting Time [521]) the PBX holds an incoming
UCD OGM Message Interval Time [522]).
1.2 Receiving Group Features
UCD Intercept Mode [524]):
Flexible Ringing—Day/Night/
1.2.4 Log-in/Log-out). The last member
Feature Guide 27