Vm 1 Apt Port [130]; Slt Ring/Silence Ratio [142]; Slt Ring Bell-On Time [143] - Panasonic KX-TEB308 Features Manual

3.3 PT Programming

VM 1 APT Port [130]

1 3 0
Notes
• To change the current setting (other than "Disable"), select "Disable", then select the desired
setting.
• This programme is not available when "Enable" is selected in DTMF Integration [103].
Feature & Programming References
1.19.1 Voice Mail APT Integration

SLT Ring/Silence Ratio [142]

1 4 2
Note
This programme selects the ratio between the bell signals of an SLT (a set of bell-on and bell-off).
Feature & Programming References
1.1.3.3 Ring Tone Pattern Selection

SLT Ring Bell-on Time [143]

SLT Ring Bell-on Time [143]
1 4 3
Notes
• This programme selects the length of the bell-on signal of an SLT. This determines the ring tone
pattern for incoming calls to SLTs, combined with the setting in SLT Ring/Silence Ratio [142].
• This programme also determines the maximum number of digits of an SLT Caller ID number, when
"DTMF1" or "DTMF2" is selected in SLT Caller ID Signalling Type [150].
Feature & Programming References
1.1.3.3 Ring Tone Pattern Selection
1.16.1 Caller ID
202 Feature Guide
NEXT SELECT
(Port03/Port03 & 04/
Disable)
NEXT SELECT
(1:2/1:3/1:4)
[On:Off]
NEXT SELECT
(1000 ... 2000 ms)
[100 ms increments]
STORE END
STORE END
STORE END