First Installation - Samsung ViasatHD DSB-H670N User Manual

Before you can view the television programme, you must perform the first installation.
Please make sure your TV is switched on.
1. Country
Press the / to choose your preferred country.
●
Press the OK key to confirm and move to the next
●
screen.
Note Note
: This selection determines the default menu
language.
The next screens will have default settings. In general you don't have to change any
default settings. Please press the OK key to use the receiver's default settings or press
the BACK key to return to the previous screen. If you want to change specific settings on
a setup screen these can be done at this installation or later on, see page 25-27.
If "First Installation Setup" is successful the TV channel on channel position 3 appears
on your TV. If there is no signal, check your installation. Check all the connections are
properly made. See also Troubleshooting on page 32.
2. LNB Setup
Press the / key to select between setup items.
●
Press the / key to select "LNB type" and "Number
●
of LNBs".
Press the OK key to confirm and move to the next
●
screen.
Press the BACK key to go to previous screen.
●
Note Note
: If more than one receiver are to be connected
to the same SATCR LNB, already installed
receivers/s has to be disconnected from the
wall socket. When the new receiver has been
installed, Previously disconnected boxes can
then be powered up again.

FIRST INSTALLATION

16
D D I I G G I I T T A A L L S S A A T T E E L L L L I I T T