Setting Up The Remote Control For Your Tv - Samsung ViasatHD DSB-H670N User Manual

SETTING UP THE REMOTE CONTROL FOR YOUR TV

You can setup your remote control to operate the basic features of your TV. This enables you to
control your TV and your receiver with just one remote control.
1. Code search
To programme your remote control to operate your television, you must first use the remote
control to find the four-digit code the corresponds to your television brand. During this code
search you will run through every available code in the remote control's library.
To search your television code:
1. Make sure that your television is switched on.
2. Press the TV key on your remote control and release it.
3. Press and hold down the SETUP key, until the red LED under the TV key blinks twice.
4. Use the numeric (0-9) key to enter 991. The red LED under the TV key blinks twice.
5. Aim the remote control at your television and press the
6. Aim the remote control at your television, and press the CH+ key repeatedly, until your
television turns off (each time you press the CH+ key the remote control sends a POWER
(TV off) signal using the next TV code contained in the remote control's library).
You may have to press the CH+ key many times (up to 150 times). The code search can take
up to 15 minutes. If you skip a code, you can search through the previous code(s) by pressing
the CH- key.
Remember to keep pointing the remote control at your television during the code search.
7. As soon as the television switched off, press the SETUP key to store this code.
The red LED under the TV key blinks twice.
8. Once it setup, you can switch the remote control to operate your TV by first pressing the
TV key. To switch back to operate your TV by first pressing the TV key. To switch back to
operate your receiver, press the VIASAT key.
2. Code blink out
Once you have found the correct code, you can use your remote control to perform a 'code blink
out' to determine what this code is.
1. Press the TV key on your remote control and release it.
2. Press and hold down the SETUP key, until the red LED under the TV key blinks twice.
3. Use the numeric (0-9) key to enter 990. The red LED under the TV key blinks twice.
4. Press 1 and count the LED blinks.
5. Press 2 and count the LED blinks.
6. Press 3 and count the LED blinks.
7. Press 4 and count the LED blinks. Now you have found the 4-digit code.
If during step 4,5,6 or 7, the LED does not blink at all, the code digit is 0.
8. For future reference, write down the code in the space provided in the remote control battery
compartment.
key.
30
D D I I G G I I T T A A L L S S A A T T E E L L L L I I T T