Table of Contents
Advertisement
Available languages
Available languages
OPERATING THE RECEIVER
2. Installation
The menu provides settings for customizing, adding new
services and displaying the status of the receiver.
●
Select "Installation" in the main menu mode to select the
sub menu.
●
Enter the PIN Code.
If you have not entered your own PIN Code then the
PIN Code 0000 applies, which was set at the factory.
2.1 LNB Setting
You can select the satellite and LNB setting conditions
to execute channel search and you can alter the settings
for 22KHz tone. The parameters set in this menu are
needed for programming the channels for the "Selective
scanning" and "Network scanning".
The necessary information can be found at your antenna
and LNB brochures, or you can ask your dealer.
●
Select LNB power supply "On".
●
Select the desired satellite name.
●
Select the LNB type (frequency).
●
Select the DiSEqC Mode
(Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)
22KHz: In case you are using a dual LNB or two antennas connected to a 22KHz tone
switch box, with the 22 KHz tone switch ("On", "Off" or "Auto") you can switch
between both LNB or antennas.
2.2 Network Scanning
The sub menu "Network Scanning" will enable scan the
channels from the LNB setting.
●
When you select "Network Scanning" menu, STB will
search all available channels from Cyfrowy Polsat NIT only.
●
Press OK key to save found programs.
GB-18
D
I
G
I
T
A
L
S
A
T
E
L
L
OPERATING THE RECEIVER
2.3 Transponder Scanning
If you have a DiSEqC 1.2 motorized system which is fully
compatible with DiSEqC1.2, then you can take advantage of
the DiSEqC 1.2 functions available.
●
Select Satellite.
●
Select any transponder from above satellites and
check out the Frequency, Symbol Rate, FEC and Polarity.
In case problems arise, ask your dealer.
Sometimes this transponder may not exist due to broadcasting.
It is better to select main transponder among them for the
desired satellite.
●
Select the Scan Mode : All or Only Free
After scanning you will see "Your digital receiver found.."
Then, you should press OK key to store all channels into STB.
Press EXIT to discard changes.
2.4 Selective Scanning
The sub menu "Selective Scanning" will enable scan the
channels automatically from the preprogrammed satellites.
To download channels automatically:
You can select All/Off/Only Free option mode with the the
/
keys in each satellite, which can be displayed more by
the PG+/PG- keys.
Off :
No Scan
All :
Scan all the channels
Only Free : Scan free channels
●
Press OK key.
Selective Scanning menu will be displayed.
All the channels in the list from the selected satellite will be
automatically downloaded.
After scanning you will see "Your digital receiver found...".
Then, you should press OK key to store all channels into STB.
I
T
E
R
E
C
E
I
V
E
R
GB-19
Advertisement
Chapters
Table of Contents
