Mixed Input Recording - JVC XL-R5000BK Instructions Manual

Mixed Input Recording

XL - R5000 CD/CDR MULTIPLE COMPACT DISC RECORDER
STANDBY
POWER
5
1
Load a recordable CD-R or CD-RW in the CDR
disc tray.
2
Press the REC ¶ button on the main unit to put
the CDR in the record pause mode.
• The remaining recording time on the disc appears in the display.
3
Select two recording sources to be mixed and
recorded.
Example:
CD and LINE are selected
CD LINE
• Press the same button again to clear the selection.
• Select the CD and LINE buttons to mix and record a CD loaded
in the 3-CD changer with the line input signals from an external
source.
• Select the CD and MIC buttons to mix and record a CD loaded
in the 3-CD changer with the input of a microphone connected
to the MIC connector.
• Select the LINE and MIC buttons to mix and record the line
input signals from an external source with the input of a micro-
phone connected to the MIC connector.
• The lamps of the selected sources light.
• Since analog signals are recorded, both the REC LEVEL and
MIX BALANCE lamps light.
MIX BALANCE
LINE CD
MIC LINE
3 1 4
REC LEVEL
MIN MAX
MIX BALANCE PHONES LEVEL
MULTI JOG
– +
62 4
MIC
REC LEVEL
MIN MAX
4
Play the two sources together and adjust the
recording level and mixing balance.
MIN
MIX BALANCE
LINE
MIC
CD + LINE CD volume is reduced.
CD + MIC CD volume is reduced.
LINE + MIC Line input volume is
reduced.
• Adjust the volume in such a way that the 0 dB display of the
level meter is not exceeded when the loudest sound is supplied.
• If the CD input is selected for mixed recording, the pitch con-
trols may be used to adjust the speed of CD playback for mixing
and recording purposes. (See page 15.)
• If the microphone level is set too high, you may experience a
loud howling sound from your speakers. If this occurs, turn
down the volume of the microphone by turning down the vol-
ume of the amp/receiver powering the speakers you are using to
monitor the sound.
• When you have finished adjusting the recording level and the
mix balance, set the sources back to the point where you want to
start recording at.
5
Start playback of the sources to be recorded.
• If the CD1 button is pressed when mixing with a CD and
recording the result, the tracks are recorded in the following
sequence: CD1 = CD2 = CD3
6
Press the CDR CONTROL 3 button to start the
recording.
When recording is complete
Press the CDR CONTROL 7 (stop) button. The 3 indicator
flashes and operation stops.
REC LEVEL
MAX
MIX BALANCE
CD LINE CD
LINE
MIC LINE
Line input volume is
reduced.
Mic input volume is
reduced.
Mic input volume is
reduced.
26