Basic Operations - JVC RV-NB10B Instructions Manual

■ ■

Basic operations

DISPLAY
SUPER WOOFER
SOUND
VOLUME +/–
ACS
VOLUME +/–
Turning the power on and off
Note: The lighting condition for the STANDBY indicator and the
display differs depending on the power source.
Power source STANDBY indicator/display
• The STANDBY indicator lights when
power is turned off.
AC power
• Backlighting of the display is illuminated
when power is turned on.
• The STANDBY indicator does not light.
• Backlighting of the display is not
Batteries or car
illuminated.
battery (DC12V)*
• With the system turned off (at standby), no
indication is shown on the display.
* If no source is playing and no operation is done for about 4
minutes, "DC OFF" starts flashing on the display for about one
minute before the system turns off automatically (except when
the source is WIRELESS/FM/AM or AUX, or when the
microphone (or guitar) is used).
Turning on the system
Press ON/STANDBY.
• When the system is operated on batteries or car battery (DC12V),
press ON/STANDBY on the system.
The STANDBY indicator goes out when the system is operated on
AC power.
The display comes on and the system is ready to continue in the
mode it was in when the power was last turned off.
or
On system
On remote control
7
ON/STANDBY
SUPER WOOFER
VOLUME +/–
ON/STANDBY
ACTIVE CLEAR
SOUND
SOUND
Turning off the system
Press ON/STANDBY again.
The STANDBY indicator lights up when the system is operated on
AC power.
• When the AC power is used, the CLOCK indicator and the time
are displayed without backlighting.
or
On remote control
On system
■
Some power is always consumed even though power is turned
off (called standby mode).
■
To disconnect the system from mains (AC) supply completely,
unplug the AC power cord from the AC outlet. When you
unplug the AC power cord, the clock will be reset to "AM12:00"
if no memory backup batteries are installed.
Adjusting the volume
You can adjust the volume level between 0 and 50.
Using the system
Turn the VOLUME +/– control clockwise to
increase the volume or turn it
counterclockwise to decrease the volume.
Using the remote control
Press VOLUME + to increase the volume or
press VOLUME – to decrease it.
When you press and hold VOLUME + or –, the volume changes
rapidly.
CAUTION: DO NOT start playing any source
without first setting the volume to minimum, as a
sudden blast of sound can damage your hearing,
speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack on the rear of
the system (see page 6). No sound comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.
VOLUME +/–
STANDBY
indicator
ACS ON/LEVEL
indicator