Listening To The Radio - JVC RV-NB10B Instructions Manual

■ ■

Listening to the radio

Number buttons
4
You can listen to FM and AM (MW/LW) stations. Stations can be tuned in manually, automatically, or from preset memory storage.
■
Before listening to the radio, fully extend the FM telescopic antenna.
Tuning in to a station
■
1.Press TUNER BAND.
Each time you press the button, the band changes as follows:
FM = AM = (back to the beginning)
The system tunes in to the last tuned station. The following
information appears on the display.
– When "Manual Tuning" or "Auto Tuning" was used to tune
in to the last tuned station (see below), the band frequency
appears.
– When "Preset Tuning" was used to tune in to the last tuned
station (see the right column), the preset number (displayed
as "P-XX" on the display) and then the band frequency
appear.
(After one second)
■
2.Select a station using one of the following
methods.
• When you tune in to an FM stereo broadcast, the STEREO
indicator lights up and you can hear stereo effect.
If an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control. The MONO
indicator lights up and the sound becomes monaural, but the
reception improves. When you tune in to another station, the
MONO indicator goes off and stereo effect restores
automatically.
Note: AM broadcasts are monaural.
■
Manual Tuning
Press 4 or ¢ repeatedly to move from frequency to
frequency until you find the station you want.
■
Auto Tuning
Press and hold 4 or ¢ for one second or more.
The frequency changes automatically until a station frequency
is found.
9
SET
¢
TUNER BAND
PRESET TUNING
FM MODE
OR
OR
4
■
Preset Tuning (possible only after presetting stations)
Select the desired preset number using PRESET TUNING on
the system or the number buttons on the remote control. The
preset number and then the band frequency appear on the
display.
PRESET TUNING button: Each time you press the button, the
Number buttons:
Notice: To adjust the reception condition
For FM: Adjust the FM telescopic antenna's length, angle and
direction until the best reception is obtained.
For AM: Change the direction of the system to obtain the best
reception.
Placing the system near the window, for example, will
improve AM reception.
TUNER BAND
¢
preset number increases.
To select P-5, press 5.
To select P-15, press +10 then 5.
To select P-20, press +10 once then
press 10.