Using The Microphone/Guitar; Using The Timer - JVC RV-NB10B Instructions Manual

■ ■

Using the microphone/guitar

Microphone/guitar mixing
Using a microphone or a guitar (not supplied), you can mix its
sound with a source sound.
■
1.Make sure the MIC/GUITAR LEVEL control
on the rear of the system is properly set.
• When using a microphone, make sure the knob is pressed in
(_).
• When using a guitar, make sure the knob is released (—).
■
2.Set the MIC/GUITAR LEVEL control to MIN
by turning it fully counterclockwise.
■
3.Connect a microphone or a guitar into the
MIC/GUITAR INPUT jack on the rear of the
system.
■
4.Start a source: disc, tape, tuner, or other
equipment.
■ ■

Using the timer

The timers let you control the listening and recording functions automatically.
Setting the clock
When the power is first supplied, the CLOCK indicator and
"AM12:00" flash on the display. Set the clock.
Note:
The clock must be correctly set for the timers to work.
Using the remote control only
■
1.Press ON/STANDBY.
■
2.Press CLOCK/TIMER repeatedly until the
CLOCK indicator lights up.
The hour digit flashes on the display.
■
3.Press ¢ or 4 to select the hour.
• When you press and hold the button, the hour digit changes
continuously.
■
5.Adjust the VOLUME +/– control and the
MIC/GUITAR LEVEL control, as you play the
microphone or the guitar.
CAUTION: DO NOT connect a bass guitar to the
MIC/GUITAR INPUT jack, as it may damage the
system.
Recording microphone or
guitar mixing on a tape
■
1.Follow the above steps
■
2.To record, follow the steps in "Standard
recording." (See page 14.)
Note: If "howling" occurs when using the microphone, keep the
microphone away from the speaker.
ON/STANDBY
CANCEL
SET
SLEEP
CLOCK/TIMER
4 ¢
■
4.Press SET to set the hour.
The minutes digits start flashing on the display.
■
5.Press ¢ or 4 to select the minute.
• When you press and hold the button, the minute digit changes
continuously.
• If you want to change the hour setting, press CANCEL.
■
6.Press SET to finish setting the clock.
CAUTION: If memory backup batteries are
exhausted or not installed, and the AC power
cord is plugged in again after being
disconnected, or power is restored after a power
failure, the CLOCK indicator will flash on the
display. Set the current time (clock) again.
– .
18