Download Print this page

Black & Decker GPC1820L-XE Original Instructions Manual

Cordless pole.
Hide thumbs

Advertisement

Australia
GPC1820L-XE
New Zealand

Advertisement

   Summary of Contents for Black & Decker GPC1820L-XE

  • Page 1

    Australia GPC1820L-XE New Zealand...

  • Page 4: Safety Instructions

    ENGLISH (Original instructions) Intended use 3. Personal safety a. Stay alert, watch what you are doing and use Your Black & Decker cordless pole pruner has been designed common sense when operating a power tool. Do not for pruning trees. This tool is intended for consumer use only. use a power tool while you are tired or under the Your Black &...

  • Page 5

    (Original instructions) ENGLISH d. Store idle power tools out of the reach of children and Additional power tool safety warnings do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power Warning! Additional safety instructions for pole tools are dangerous in the hands of untrained users.

  • Page 6

    (Original instructions) ENGLISH Switch the tool off, allow the chain to stop and remove the Consider access to the tree limb.   battery from the tool before carrying out any adjustment, Tree branches are liable to swing towards the tree trunk. In servicing or maintenance.

  • Page 7

    (Original instructions) ENGLISH Health hazards caused by breathing dust developed Symbols on the charger  when using your tool (example:- working with wood, The following symbols are found on your charger: especially oak, beech and MDF). Your charger is double insulated; therefore no Additional safety instructions for batteries and chargers earth wire is required.

  • Page 8

    (Original instructions) ENGLISH Align the groove on the outside of the coupling end of the To charge the battery (11), remove it from the tool and   handle (3) with the tongue on the inside of the coupling end of the saw head (4). Push the saw head (4) onto the the charger in one way.

  • Page 9

    (Original instructions) ENGLISH Remove the sprocket cover (5) and the bar clamp (17).  Turn the screw (18) counterclockwise to allow the guide Make sure the tool is running at full speed before making   bar (6) to recede and to reduce the tension on the saw a cut.

  • Page 10

    The storage temperature must always remain in the range Technical data  of +10°C to +40°C. Place the battery on a level surface. Before using the tool after prolonged storage, fully charge  GPC1820L-XE H1 the battery again. Input voltage Vdc 18 Protecting the environment No-load chain speed...

  • Page 12

    Australia & New Zealand Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia Tel. 1800 444 224 (Aust) or Tel. +0800 339 258 (NZ) 90582918 03/2012...

This manual also for:

Gpc1820l

Comments to this Manuals

Symbols: 0
Latest comments:
  • Helen Blair Mar 12, 2016 08:37:
    Can someone please provide a NAME list of parts 1-23?