Riso RZ Series Manual page 89

ORCH_GB.book Page 89 Thursday, February 19, 2004 2:08 PM
Location Error No.
No.
b-22
b-23
b-24
b-31
b-32
Non
b-33
F-05
F-58
When the indicator [Area *3] lights
Because the entire master roll has been consumed, set a new master roll.
p.70
When the indicator [Area *3] lights
Because the Master Disposal Box is full, remove the box and discard the ejected masters.
p.73
When the indicator [Area *3] lights
Because the Ink Cartridge becomes empty, replace with a new Ink Cartridge.
p.68
When the indicator [Area *3] lights
Check error numbers shown on the Error Number Display and contact your dealer.
When the indicator [Area *3] lights
Contact your dealer and take a periodic inspection.
Cause
Power to the Job Separator (option) is
off.
The Job Separator (option) has run out
of tape.
A tape jam has occurred in the Job
Separator (option).
Data send to the Linked Printer
(option) has failed.
Power to the Linked Printer (option) is off.
Another possible cause is an
inappropriate cable connection or
cable line disconnection.
An IP address has not been set for the
machine.
An attempt is being made to print a
smaller number of copies than the
minimum print quantity.
Because the RISORINC-NET has
been initiated, the Linked Printer
(option) cannot be used for output.
Troubleshooting
Action
Turn on the power to the Job Separator.
Set new tape to the Job Separator.
Check the Job Separator and remove the
jammed tape.
• Check that the cables of the Linked Printer
and the machine have been correctly
connected to the hub, for example.
• If the cable connections are appropriate,
check the communication status of the
server and/or network.
• Check with the manager of the server or
network.
• Check that the Linked Printer has been
switched on.
• Connect the cables correctly.
Using the Custom Setting mode, set the IP
address for the machine.
p.65
Select a larger number of copies than the
minimum print quantity.
p.59
• To output from the machine
Press the key, and then press the
key.
• To output from the Linked Printer.
Press the key, wait for a while, and then
try again.
Check & Error Display
89